Audiopipe APK-700.5 - Manual (Page 8)

5. SPEAKER CONNECTIONS
5-1. DIGITAL MONOBLOCK SPEAKER CONNECTION
This terminal connects amplifiers to the speakers . Minimum speaker cable should be
12 gauge or larger. Connect the subwoofer speakers by checking the impedance 1 ohm
for single unit or 2 ohm for strappable connection.
5-2. DIGITAL MONOBLOCK LINK CONNECTION
INPUT CONNECTION ;
Step 1. Connect the master amplifier to the head-unit and set its output master / input slave
switch to output master.
Step 2. Set slave amplifier output master / input slave switch to slave input.
Step 3. Connect RCA cable from the master to slave amplifier as shown in the diagram.
8 ~ 1ohm 8 ~ 2ohm 8 ~ 2ohm
MASTER AMPLIFIER
SLAVE AMPLIFIER
+12V SOURCE
Fully adjusted signal is
transferred from master
to slave amp via Rca cable