Audiopipe APK-700.5 - Manual (Page 5)

4-3. FULL RANGE 4CHANNEL
REMOTE PORT
This port is for remote level control.
Plug remote control’s connector for
remote level control’s use.
Remote controls level from
the driver’s seat.
POWER & PROTECT LED
Power LED :
Green-lit shows correct operation.
Protect LED :
Red-lit shows general malfunction,
faulty connection, thermal overload,
speaker short protection.
GAIN ( 6V ~ 0.2V )
Used to reach maximum amplifier
power by matching the output
voltage of with a wide variety of
the headunits
RCA INPUT
RCA INPUT :
Connect preamp signal
cables from the source
or the headunit to RCA
input
HIGH PASS FILTER ( 20~5KHz @12dB )
Controls the high pass filter frequency
for the speaker output.
The Low pass filter is always on with
12dB per octave slope.
BASS BOOST ( 0 ~ 18dB )
The bass boost boosts frequency
centered at 45Hz.
LOW PASS FILTER ( 50~500HZ @12dB )
Controls the low pass filter frequency
for the speaker output.
The Low pass filter is always on with
12dB per octave slope.
X-OVER ( HPF-FULL-LP/BP )
It selects the crossover as High pass,
Full and Low pass & Band pass filter.
The selected crossover has effect.
HIGH PASS FILTER ( 20~5KHz @12dB )
Controls the high pass filter frequency
for the speaker output.
The Low pass filter is always on with
12dB per octave slope.
X-OVER ( HPF-FULL-LP/BP )
It selects the crossover as High pass,
Full and Low pass & Band pass filter.
The selected crossover has effect.