I/o panel, Removing the i/o panel – Dell OptiPlex GX270 User Manual
Page 13
Back to Contents Page
I/O Panel
Dell™ OptiPlex™ GX270 Service Manual
1.
Shut down the computer through the Start menu.
2.
Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
3.
Disconnect any telephone or telecommunication lines from the computer.
4.
Disconnect your computer and all attached devices from electrical outlets and press the power button to ground the system board.
5.
If you have installed a padlock through the padlock ring on the back panel, remove the padlock.
6.
Open the computer cover.
Removing the I/O Panel
1.
On the small form-factor computer, to access the screw that holds the I/O panel to the computer, remove the hard drive.
2.
On the small desktop computer, disconnect the hard-drive data cable.
3.
Disconnect all cables that are connected to the I/O panel.
Note the routing of the control panel cable as you remove it from the computer so that you can replace it correctly.
4.
From inside the computer cover, remove the mounting screw that secures the I/O panel to the computer.
5.
Remove the I/O panel from the computer.
Small Form-Factor Computer
CAUTION:
Before you begin any of the procedures in this section, follow the steps in "
Safety Instructions
."
NOTICE:
Before you disconnect a device from the computer or remove a component from the system board, verify that the standby power light on the
system board has turned off. To locate the light, see "
System Board
."
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the
computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
1 internal speaker cable
4 mounting screw