Bosch AHS 550-24 ST - Manual (Page 12)

English - 4
Before any work on the machine itself, pull
the mains plug.
Wear gloves when handling or cleaning the cutting
blade.
Always clean the cutting blade after operation and
lubricate with protective spray. During longer cutting
jobs, we recommend periodically lubricating the cut-
ting blade with protective spray.
Visually check the condition of the cutting edges of
the cutting blade 1. Check tightness of blade bolts.
Ensure that the blade is covered with the blade
guard 7 supplied.
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all debris, especially from the
ventilation slots 4.
Store the hedgecutter in a secure, dry place out of
the reach of children. Do not place other objects on
top of the machine.
Blade guard AHS 400 - 24T .................. 2 605 411 160
Blade guard AHS 480 - 24T .................. 2 605 411 160
Blade guard AHS 550 - 24ST ............... 2 605 411 208
Blade guard AHS 600 - 24ST ............... 2 605 411 208
Blade guard AHS 650 - 24ST ............... 2 605 411 158
Blade guard AHS 6000 PRO-T ............ 2 605 411 208
Blade guard AHS 7000 PRO-T ............ 2 605 411 158
Collecto AHS 400 - 24T ........................... 2 608 005 112
Collecto AHS 480 - 24T ........................... 2 608 005 114
Collecto AHS 550 - 24ST ........................ 2 608 005 115
Collecto AHS 600 - 24ST ........................ 2 608 005 115
Collecto AHS 650 - 24ST ........................ 2 608 005 113
Collecto AHS 6000 PRO-T ..................... 2 608 005 115
Collecto AHS 7000 PRO-T ..................... 2 608 005 113
Lubricant spray ............................................. 1 609 200 399
Clipping sheet ............................................... F 016 800 055
Protective goggles ...................................... 2 607 990 041
Gloves .............................................................. 2 607 000 134
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Blade Maintenance
Cleaning/Storage
Accessories
Fault Finding
Symptom Possible Cause Remedy
Hedgecutter fails to
operate No power
Mains socket faulty
Extension cord damaged
Fuse faulty
Check power
Check other socket, replace
Check cord, replace
Replace fuse
Hedgecutter operates
intermittently Extension cord damaged
Internal wiring defective
On/Off switch(es) defective
Check cord, replace
Contact service agent
Contact service agent
Motor runs but blades
remain stationary Internal fault Contact service agent
Cutting blade hot Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of
lubricant
Have blade sharpened
Have blade overhauled
Apply lubricant spray
F016 L70 366 - Buch Seite 4 Freitag, 23. September 2005 11:14 11
12 • F016 L70 366 • 05.09