SUUNTO Combo - Manual (Page 6)

6
CB-ONE Module Assembly when using the SUUNTO Quick Release
If the SUUNTO Quick Release (QR) is used the hose cover should be attached on the high
pressure hose below the female end of the QR. The male part is attached to the pressure
gauge which is then fi tted onto the CB-ONE front cover according to the picture below.
CB-IN-LINE Module Assembly
The CB-IN-LINE module fi ts the Suunto Vyper, Gekko, Solution, Favor/Fusion, Octopus II and
Companion dive computers or the SM-16 round depth gauge.
The Vyper locks in place on the IN-LINE module back cover. For the other instruments there
are lugs on the back cover aiding the orientation.
The Solution, Favor and Companion can be fi tted with display shield V5615. The display
shield is attached after the console has been assembled by bending the console so that
the shield fi ts between the computer and the console cover. The Vyper is delivered with a
pre-attached display shield (V5875).