Install the battery, Charge the gps 10x receiver, Install garmin mobile – Garmin Mobile PC User Manual
Page 4: Pc on your laptop
Garmin Mobile PC with Wireless GPS Receiver Quick Start Manual
➊
Install the Battery
1. Locate the black or gray lithium-ion battery that
came in the product box.
2. With your thumbnail, slide the battery cover release
tab toward the end of the GPS 10x.
3. Pull the battery cover off.
4. Locate the metal contacts on the end of the battery.
Insert the battery so the metal contacts on the
battery match up with the ontacts inside the battery
compartment. Press the battery down into place.
5. Replace the battery cover by inserting the tabs into
the notches. Press the battery cover closed; the
release tab locks the cover in place.
Release
tab
Battery cover
Lithium-ion battery
WaRNiNG: This product contains a lithium-ion battery. To
prevent damage, remove the unit from the vehicle when exiting
or store it out of direct sunlight.
Replacement Battery
If you need to replace the battery, use a Garmin 3.7
Volt lithium-ion battery pack (010-10840-00). Purchase
. You
can also use a compatible cell phone battery, such as a
Nokia BL-5C.
➋
Charge the GPS 10x Receiver
1. Plug the small end of the power cable into the mini-
USB connector on the end of the GPS 10x.
2. Plug the other end of the power cable into an
available power outlet in your vehicle.
You can use the GPS 10x receiver while you are
charging it. It takes about four hours to charge the
battery. A fully charged battery lasts about 22 hours.
➌
Install Garmin Mobile
®
PC on
Your Laptop
Garmin Mobile PC is compatible with Windows
®
2000
SP2, XP, and Windows Vista
®
operating systems.