Binatone NHB-7705 - Manual (Page 5)

5
ENGLISH
SPECIAL SAFETY MEASURES
X Before turning the appliance on for the first
time, make sure that all components of the blender
have been properly installed.
X Do not apply too much force when installing the
blender attachment, as it may result in the break-
age of the appliance and in the termination of the
warranty.
X If a smell of burning, foreign sounds or power reduction occur
during the blending process, immediately unplug the appli-
ance from the outlet and clean the blender. If the blender still
malfunctions after cleaning, contact an authorized service cen-
ter.
X It is recommended that original factory packaging should be
used for the transportation of the blender in order to prevent
its parts from breaking.
X If the ingredients are hot, allow them to cool before blending
(maximum temperature: 80 0 C). Never blend hot fat or oil with
the blender.
X Never use the blender to blend paints or solvents.
X Do not attempt to remove any ingredients when the blender is
in operation.
X Always turn the appliance off before removing the attach-
ment.
X The continuous operation of the blender should last for no
more than 1 minute and should be then interrupted for at least
1 minute.
X The blades of the blender are very sharp. Never touch the
blades of the blender.
X Turn the blender on only after it has been fully assembled.
Always check whether the appliance has been properly as-
sembled before each use.
PARTS OF THE APPLIANCE
Figure A:
1. Body of the appliance
2. Speed selector
3. Power on/off button
4. Blender attachment
5. Whisk attachment
6. Blender drive unit
7. Non-skid base/ storage lid
8. Blender blade unit
9. Blender bowl
10. Mixing cup
11. Power cable
12. Wall mount