ASRock Fatal1ty Z68 Professional Gen3 - Manual (Page 34)

34
Fatal1ty Z68 Professional Gen3 Series Motherboard
the red-striped side to Pin1
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.4 No. 31)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Black)
(39-pin IDE1, see p.4 No. 8)
Note: Please refer to the instruction of your IDE device vendor for the details.
connect the black end
to the IDE devices connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
English
SA
TA2_2_3 SA
TA2_4_5
SA
TA3_A3_A4 SA
TA3_A1_A2 SA
TA3_0_1
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATA2_2_3: see p.4, No. 13) connectors support SATA data
(SATA2_4_5: see p.4, No. 12) cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA3 Connectors These six Serial ATA3 (SATA3)
(SATA3_0_1: see p.4, No. 14) connectors support SATA data
(SATA3_A1_A2: see p.4, No. 15) cables for internal storage
(SATA3_A3_A4: see p.4, No. 16) devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_A4 will not function.