Acura 2008 RDX - Manual (Page 387)

The brake system indicator (red)
normally comes on when you turn
the ignition switch to the ON (II)
position, and as a reminder to check
the parking brake. It will stay on if
you do not fully release the parking
brake.
If the brake system indicator (red)
comes on while driving, the brake
fluid level is probably low. Press
lightly on the brake pedal to see if it
feels normal. If it does, check the
brake fluid level the next time you
stop at a service station (see page
).
If the fluid level is low, take your
vehicle to a dealer, and have the
brake system inspected for leaks or
worn brake pads.
However, if the brake pedal does not
feel normal, you should take
immediate action. A problem in one
part of the system’s dual circuit
design will still give you braking at
two wheels. You will feel the brake
pedal go down much farther before
the vehicle begins to slow down, and
you will have to press harder on the
pedal.
Slow down by shifting to a lower
gear, and pull to the side of the road
when it is safe. Because of the long
distance needed to stop, it is
hazardous to drive the vehicle. You
should have it towed, and repaired as
soon as possible (see
on page ).
You will also see a ‘‘BRAKE FLUID
LOW’’ message on the multi-
information display (see page
).
You will also see a ‘‘CHECK BRAKE
SYSTEM’’ message on the multi-
information display (see page
).
If you must drive the vehicle a short
distance in this condition, drive
slowly and carefully.
If the ABS indicator and the VSA
system indicator come on with the
brake system indicator, have your
vehicle inspected by your dealer
immediately.
345
77
77
391
Brake System Indicator
Brake System Indicator (Red)
Emergency
Towing
T
a
k
ing
Ca
re
of
th
e
U
ne
x
p
e
c
te
d
383
Canada U. S.
2008 RDX
Table Of Contents Main Menu