Acura 2014 RLX Navigation - Manual (Page 133)

132
Re
fe
re
nce
Inf
o
rma
tio
n
System Initialization
The navigation system must be initialized if
power to the navigation system is
interrupted for any reason (e.g., the
battery was disconnected).
Entering the Security Code
Find the navigation system’s security
code and serial number label in your
Owner’s Manual kit. Do not store the
label in your vehicle. If you lose the label,
you must first retrieve the serial number,
and then obtain the code. You can find
out about your serial number and
security code from a dealer.
1. Set the power mode to ON, and turn on
the audio system.
 If you set the power mode to
ACCESSORY, you will be requested
to enter the security code. See step 3.
2. Press and hold the PWR 9 (Power)
button for more than two seconds.
 The system is reactivated when the
system’s control unit recognizes that
the system is in your vehicle.
If the control unit fails to recognize,
“ENTER CODE” appears on the
navigation screen.
3. If necessary, enter the security code.
 If you do not enter the security code
correctly after 10 tries, leave the
system for one hour before trying
again, or visit a dealer to have the
system reset.
NOTE:
In the U.S. you can register the security
code at My Acura (owners.acura.com), and
find information on how to retrieve the
serial number and obtain the code at
radio-navicode.acura.com.
Acquiring GPS Information
Depending on the length of time the
power was interrupted, your system may
require GPS initialization.
If initialization is not necessary, the system
proceeds directly to the Startup
Confirmation screen.
If the system fails to locate a sufficient
number of satellites to locate your
position within 10 minutes, the following
screen is displayed.
RLX_KA-31TY2800.book Page 132 Tuesday, October 9, 2012 10:41 AM
QRG
2014 RLX