Acumen AiP-Y14D - Manual (Page 23)

22
The IP Speed Dome Camera supports totally four Tour Path; each Tour Path consists of up to 32
Preset Points. Please refer to the instructions below to program a Tour table.
NOTE: Before setting this function, users must pre-define at least two Preset Points.
Tour Path Setting

Tour Path
Please select the number of Tour Path to be set from the drop-down list in the top of the Tour Setup menu.

Sequential Preset Points Setting
Please setup each Preset Point of the programmed Tour Path in order, assigning a Preset Point from the
list for the specified number of Preset Point. Finally, Click on the button to save the settings mentioned
above.
3-6-2.5 Patrol Setup
The Patrol Path Programming can be found under this path: PTZ> PTZ Advance> Patrol Setup
The IP Speed Dome Camera supports up to four Patrol Paths. Please follow the instructions below
for Patrol Path setup.
Patrol Path Setting
To setup a Patrol Path, please first select a path number from the drop-down list. Then move the cursor to the PTZ
control pane, and move the camera to a desired view (PTZ controls) as the start point of a Patrol Path. Click on the
button to start record and start programming the Cruise Path via PTZ control. When finishing programming,
click on the button to quit. Then this Cruise Path will be automatically recorded.
Chapter 3-6-3 PTZ Schedule Settings
To setup PTZ scheduling, please select PTZ schedule link. Use the mouse select on the radio
button of the preset types, None, Autopan, Preset #1, Preset #2, Preset #3, and Preset #4.
Click on the hour of the calendar control to configure the preset action.