AcuRite 75328T Clock - Manual (Page 2)

7 2
BASIC SETUP
EST
Atomic Clock
Signal Indicator
Time Zone Indicator
(Defaults to Eastern Standard Time)
Day/Date
Calendar
Moon Phase
Indicator
Outdoor Temperature Sensor
Signal Indicator
Outdoor Temperature
with Trend Arrow
Indoor Temperature
with Trend Arrow
AM / PM Indicator
(Defaults to Fahrenheit)
1. Battery Installation - BEGIN WITH THE OUTDOOR WIRELESS SENSOR
2. Initial Setup - once the batteries are installed, the clock will power up. The display will
appear as follows:
Remove the batteRy compaRtment coveR on the
back of the clock and install 6 fResh “aa” alkaline
(only) batteRies as shown heRe
wiReless sensoR
3
Remove
batteRy
compaRtment
coveR
1
install 2 “aa”
batteRies.
alkaline oR lithium
2
Product Specifications
Indoor Temp. Range = 32°F to 140°F (0°C to 60°C)
Outdoor Temp. Range = -40°F to 158°F (-40°C to 70°C)
Atomic Clock Frequency = WWVB 60Khz
433Mhz - Radio Signal
Synchronizes daily
100' (30m) Radio Frequency Transmission Range
Power Requirements = (8) "AA" Alkaline Batteries
BATTERY SAFETY:
Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment
which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment.
Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or
equivalent type as recommended are to be used.
DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT
use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY
AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
LIMITED ONE YEAR WARRANTY - Chaney Instrument Company warrants that all products it manufactures to be
of good material and workmanship and to be free of defects if properly installed and operated for a period of one
year from date of purchase. REMEDY FOR BREACH OF THIS WARRANTY IS EXPRESSLY LIMITED TO REPAIR OR
REPLACEMENT OF DEFECTIVE ITEMS. Any product which, under normal use and service, is proven to breach the
warranty contained herein within ONE YEAR from date of sale will, upon examination by Chaney, and at its sole option,
be repaired or replaced by Chaney. In all cases, transportation costs and charges for returned goods shall be paid for
by the purchaser. Chaney hereby disclaims all responsibility for such transportation costs and charges. This warranty
will not be breached, and Chaney will give no credit for products it manufactures which shall have received normal
wear and tear, been damaged, tampered, abused, improperly installed, damaged in shipping, or repaired or altered by
others than authorized representatives of Chaney.
The clock will initially set itself to the correct time and date, defaulting to EST (Eastern Standard
Time). It will also begin displaying the temperatures. The clock will begin searching for the
Atomic signal.
Note: The clock will adjust for daylight saving time, even if it is unable to receive the WWVB signal
After the clock acquires the Atomic signal (this may take 24-48 hours) the time, date and
daylight saving time changes will update automatically, giving you maintenance-free operation
and accuracy to the split second
atomic digital clock
*NOTE: indoor unit should not be placed in conditions
under 32˚F