AcuRite 13022 Alarm Clock - Manual (Page 9)

9
Using the Clock
Set the Alarm Time
Slide Alarm #1 and/or Alarm #2 switch ON (alarm time cannot be adjusted if
the alarm is OFF).
Press and release the “ ” or the “ ” button to enter ALARM SET
MODE.
To adjust the currently selected (flashing) item, press and release the “ ” or
“ “ buttons (press and HOLD to fast adjust).
To save your adjustments, press and release the “ ” or “ “ button to
adjust the next preference. The preference set order is as follows:
ALARM CLOCK HOUR
ALARM CLOCK MINUTE
ALARM EVERY DAY or WEEKDAY ONLY or WEEKEND ONLY
You will automatically exit ALARM SET MODE if no buttons are pressed for 5
seconds. Enter ALARM SET MODE at any time by pressing the “ ” or
“ “ button.
Backlight
During power adapter use, press the Snooze button for momentary backlight
at 100% brightness. During battery-powered use, press any button for
momentary backlight.
The backlight MAY turn off at 2:00AM and 3:00 AM to acquire the atomic
clock (RCC) signal.
USB Charging
Charge your mobile device by plugging your device’s USB
power cord (not included) into the USB charging port on
the back of the clock.
USB charging is only available during power adapter use;
USB charging is not active when operating on battery power
only.
Note: Follow the manufacturer’s instructions for your mobile
device(s) to determine compatibility with the USB charging
feature on this product. Some devices may not support USB charging or
may require a higher power rating than this product provides. Observe the
charging status on your device. Ensure your device is working properly before
attempting to charge.
DIMMER
+
-
VOLUME
ALARM
+
-
DC 4.5 v CHARGE
USB DEVICE
OPERATION
1
2
1
1
2
2