Activeforever Geemarc AMPLI600 Emergency Response Phone - Manual (Page 12)

12
SETTINGS
Dialling Mode
The Tone/Pulse is factory pre-set to Tone (Tone). In the US, all telephone
exchanges now use Tone dialling. If your phone does not dial out, it is
probably being used from an older private switch-board (PBX). In this case,
theTone/Pulse setting must be moved to Pulse (Pulse).
Press MUTE
Use ▲ or ▼ to select ‘SET PHONE’
Press OK
Use ▲ or ▼ to select ‘TONE /PULSE’
Press OK
Select ‘TONE’or‘PULSE’
Press OK to confirm
Press C three times to exit