Activeforever AutoCloser Automatic Garage Door Closer User Manual

Page 24

STEP 4

Press and release the Disable button
while the unit is on. Does the unit
beep twice?

No- Go to Step 1 and re-
align the reflector.

Yes- Go to Step 5

STEP 5

1) Are you sure you are waiting the

full delay time?

No- Press and hold the

Disable button. The unit will
beep twice initially, then af-
ter 5 seconds it will beep
once. Release the disable
button. This sets the delay
time to 2 minutes.

Yes- Go to Step 6

2) Retest Autocloser function and

wait the full two minutes. Does the
unit work?

• No- Go to Step 6

• Yes- Unit is working

STEP 6

1) Disconnect unit from the garage

door opener.

2) Plug it in to any wall outlet.
3) Hold the unit about a foot away

from the wall and switch it to
‘setup’. It should continually beep.

4) Switch it to 'on'.
5) Hold the unit about a foot away

from the wall.

6) Wait for the delay timer to com-

plete it’s count (Remember to
keep holding the unit facing the
wall. If the unit doesn't think the
reflector is in the open position, it
will not go into closer mode.) The
unit should begin beeping after
the delay timer finishes it’s count.