ACR&Artex AeroFix 406 GPS PLB - Manual (Page 11)

Note: Use care when attaching items to your P-ELT. Clipping attachments, carabineers, rope,
webbing, etc. will all add weigh and can affect the buoyancy of the P-ELT. Your P-ELT may not
float if items have been attached to it.
Figure 8.
Removable Holster
To Open the Holster, squeeze inward on the two tabs located on the bottom clip and pull up on the top of the
holster. Rotate antenna up, and slide the holster off around the antenna.
To secure antenna when the holster is on your AeroFix™, be sure to deploy antenna prior to placing the
holster onto the unit. Slide the antenna through the holster to secure it to the beacon. The holster will clip
together at the bottom of holster. Rotate antenna into down position in order to wrap it around the holster to
lock it in place. Make sure the antenna runs between the two guides on the bottom of the holster. This will
prevent the antenna from slipping out of position. Finally lock the antenna into place by engaging the tab
located on the antenna into the slot provided on the top right corner of the holster. Slide it in to lock in place.
5.3
The AeroFix™ also comes with a bulk head mounting clip that allows you to easily mount your P-
ELT to your console or bulk head. Simply bolt the mounting clip to your desired location and slide
the P-ELT onto the clip ensuring that the bottom back of the holster slides over the clip to secure it
in place (See figure 9).
Y1-03-0175 Rev. E 10
Connect GPS Interface Cable
to the bulk head mount
when P-ELT is not attached.
Figure 9.
Bulk Head Mount
Holster opening for the
bulk head mount.