Acnodes FPC 5121 - Manual (Page 3)

FPC 5121
Industrial Fanless Panel PC
Safety Precautions
Before getting started, please read the following im portant safety precautions.
1. The FPC5121 does not come equipped with an operating s ystem. An operating
system m ust be loaded first before installing any software into the com puter.
2. Be sure to ground yours elf to prevent static charge when installing the internal components.
Use a grounding wrist strap and place all electronic components in any static-shielded
devices. Most electronic components are sensitive to static electrical charge.
3. Disconnect the power cord from the FPC5121 before any installation. Be sure both the
system and external devices are tur ned OFF. A sudden surge of power could ruin
sensitive components that the FPC5121 must be properly grounded.
4. The brightness of the flat panel display will be getting weaker as a result of frequent usage.
However, the operating period varies depending on the application environment.
5. Turn OFF the system power before cleaning. Clean the s ystem using a cloth only. Do not
spray any liquid cleaner directly onto the scr een. The FPC5121 comes with a
touchscreen. Although the touchscreen is chem ical resistant, it is recommended that you
spray the liquid cleaner on a cloth first before wiping the screen. In case your system comes
without the touchscreen, you must follow the sam e procedure and not spray any cleaner on
the flat panel directly.
6. Avoid using sharp objects to operate the touchscreen. Scratches on the touchscreen m ay
cause m alfunction or internal failure to the touchscreen.
7. The flat panel display is not susceptible to shock or vibr ation. W hen assembling the
FPC5121, make sure it is securely installed.
8. Do not open the system ’s back cover. If opening the cover for maintenance is a must, only a
trained technician is allowed to do so. Integrated circuits on computer boards are sensitive
to static electricity. To avoid damaging chips from electrostatic discharge, observe the
following precautions:
 Before handling a board or integrated circuit, touch an unpainted portion of the system
unit chassis for a few seconds. This will help to discharge any static electricity on your
body.
 W hen handling boards and components, wear a wrist-grounding strap, available from
most electronic com ponent stores.
14628 Central Ave,
Chino, CA 91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2013 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.