Pc 6412 – Acnodes PC 6412 User Manual

Page 40

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 6412

12.1” Fanless Panel PC

4.10 Mounting the System

WARNING!

When mounting the flat panel PC onto an arm, onto the wall or into a wall, it is better to

have more than one person to help with the installation to make sure the panel PC does

not fall down and get damaged.

The methods of mounting the PC Series-N270 are listed below.

Wall mounting

Arm mounting

Rack mounting

The mounting methods are described in the following sections.

4.10.1 WALL SURFACE MOUNTING

To mount the panel PC onto a wall, please follow the steps below.

Step 1: Select the location on the wall for the wall-mounting bracket.

Step 2: Carefully mark the locations of the four bracket screw holes on the wall.

Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention

screws.

Step 4: Align the wall-mounting bracket screw holes with the pilot holes.

Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into

the four pilot holes and tightening them.

Step 6: Insert the four monitor mounting screws provided in the wall mounting kit into

the four screw holes on the real panel of the flat panel PC and tighten until the screw

shank is secured against the rear panel (Figure 4-16).

Step 7: Align the mounting screws on the monitor rear panel with the mounting holes

on the bracket.

Step 8: Carefully insert the screws through the holes and gently pull the monitor down-

wards until the monitor rests securely in the slotted holes (Figure 4-16).

Ensure that all four of the mounting screws fit snuggly into their respective slotted holes.