Lcd session, Resolution settings, For sun servers – Acnodes KDI 8198 User Manual
Page 16: Supported resolution mode for 15” lcd, Supported resolution mode for 17” lcd, As root, Type “/user/sbin/m64config – prconf, The screen will be rubbish, Then type “pkill xsun, And type “pkill xsession” to restart the xsession
User Manual
10. LCD Session
Resolution Settings
For SUN Servers
●
Resolution configuration procedures should be run by qualified SUN
server administrator
●
Sun Servers are using resolution at 1152 x 900 x 76Hz.
●
Supported resolution mode for 15” LCD:
●
1024 x 768 x 70/75Hz
●
Supported resolution mode for 17” LCD:
●
1280 x 1024 x 75Hz
●
You need to change the Sun Server resolution before you connect to
LCD Display.
●
Please do the following procedures to change the resolution settings :
1. As root:
You may find the following comment “/user/sbin/m64config”.
2. To view current resolution:
Type “/user/sbin/m64config – prconf”.
3. To change to 1024x768 @ 70MHz:
Type “/user/sbin/m64config – res 1024x768x70 now”.
4. The screen will be rubbish.
5. Then type “pkill Xsun”.
And Type “pkill Xsession” to restart the Xsession.
Note : Remember to RESTART the server after these processes.
●
Under Common Desktop Environment (CDE).
●
To change the OpenBoot resolution, you can type the following
command in OK prompt.
1. In OK prompt, type “setenv output-device screen:r1024x768x70”.
2. Type
“ pri ntenv” to confi rm the resol ution has been changed to
1024x768x70Hz.
3. Then type, “reset” to restart the system.
Note : Remember to RESTART the server after these processes.
Rev. : 1.0
P.15