Acme BH05 - Manual (Page 5)

5
GB
Switch the call between phone and headset
During a conversation, press and hold the Answer/end button for 2 Seconds, the BH05 will
be switched off and the call will be transferred to your mobile phone. If you want to transfer
the call back to your BH05 press and hold the Answer/end for 2 seconds till you hear a beep.
Release the button and the call is transferred back to your BH05.
Battery information
Your device is powered by a rechargeable battery. The full performance of a new battery is
achieved only after two or three complete charge and discharge cycles. The battery can be
charged and discharged hundreds of times, but it will eventually wear out. Recharge your
battery only with compatible chargers designated for this device.
Unplug the charger from the electrical plug and the device when not in use. Do not leave a
fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left
unused, a fully charged battery will lose its charge over time.
Never use any charger that is damaged.
Leaving the device in hot or cold places, such as in a closed car in summer or winter conditions,
will reduce the capacity and lifetime of the battery. Always try to keep the battery between
15ºC and 25ºC (59ºF and 77ºF). A device with a hot or cold battery may not work temporarily,
even when the battery is fully charged. Battery performance is particularly limited in
temperatures well below freezing.
Do not dispose of batteries in a fire as they may explode. Batteries may also explode if
damaged. Dispose of batteries according to local regulations. Please recycle when possible.
Do not dispose as household waste.
Care and maintenance
Your device is a product of superior design and craftsmanship and should be treated with care.
The suggestions below will help you protect your warranty coverage.
· Keep all accessories and enhancements out of the reach of small children.
· Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can
contain minerals that will corrode electronic circuits. If your device does get wet, allow it to
dry completely.
· Do not use or store the device in dusty, dirty areas. Its moving parts and electronic
components can be damaged.
· Do not store the device in hot areas. High temperatures can shorten the life of electronic
devices, damage batteries, and warp or melt certain plastics.
· Do not store the device in cold areas. When the device returns to its normal temperature,
moisture can form inside the device and damage electronic circuit boards.
· Do not drop, knock, or shake the device. Rough handling can break internal circuit boards
and fine mechanics.
· Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
· Do not paint the device. Paint can clog the moving parts and prevent proper operation.
All of the above suggestions apply equally to your device, battery, charger, or any enhancement.
If any device is not working properly, take it to the nearest authorized service facility.