Acme KB200 - Manual (Page 5)

5
GB
operation
It is recommended to use the kettle for several times following instructions given below and to remove remaining
water before first usage. This will remove any materials or dust remained in the appliance from the manufacturing
process.
1. Open the lid by turning the Lid up while pressing the Lid button and pour water into the kettle. Then replace the
lid, otherwise the kettle would not be able to turn off the power automatically after water has boiled.
Caution: the filled water level must be between the “Max” and “Min” level as indicated on the housing. Too little water
will damage the heat element and if the kettle is overfilled, boiling water may splash out.
2. Replace the kettle on the power base and connect to power supply. Position the kettle so that the spout of the
kettle is facing away from you.
3. Press the switch button to “I” position and the light will flash on. And water will start to heat up. Do not open the
lid while the water is boiling.
Caution: Ensure that the switch is clear of obstructions and the lid is firmly closed. The kettle will not turn off if the switch
is constrained or if the lid is left open.
4. Power will be cut off automatically and the switch will be back to “0” position once water has been boiled. And
the light will be off.
5. Lift the kettle from the power base and then pour the water.
Note: Be careful when pouring water from the kettle, as boiling water
may cause scalding.
6. The boiling process can be terminated at any time by lifting the
kettle off the power base or pressing the switch to “0” position.
caution
• Never use the appliance when it is empty. If such situation will occur, the thermal cut-off inside the kettle would
turn off the power automatically. Unplug the appliance and let it cool down completely.
• The filter must be in place during the work of the appliance otherwise water spillage may occur.
Note: Ensure the power is turned off while the kettle is not in use.