VALERA TURBO STYLE 1000 TOURMALINE - Manual (Page 4)

4
• Do not pull the plug out of the power supply socket when your hands are wet.
• When using the appliance make sure the air intake and exhaust grilles are never
obstructed. This unit is fitted with a device to guard against overheating that switches it
off immediately when the temperature gets too high. Should this happen, move the
switch to the 0 position and leave it to cool for 5 minutes.
• Always allow the unit to cool before putting it away and never wrap the cord around the
unit.
• Check that the cord has not been damaged from time to time.
• Do not use your unit if it is not working properly, if it has fallen or if the cord is damaged.
Do not try to repair this electrical unit yourself, rather contact an authorized technician.
• The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out
of reach of children as they are a potential danger to them.
• This unit must only be used for the purposes for which it is expressly intended. Any
other use is to be considered improper and therefore dangerous. The manufacturer
accepts no responsibility for damage caused by improper or erroneous use.
• Do not use hair spray while the unit is running.
• To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
• Warning - The metal parts overheat if used for too long. Be careful and allow these parts
to cool before touching them.
Important
This hairdryer conforms to the safety regulations regarding electrical appliances.
This hairdryer has a safety cut-out which will operate in case of overheating. The dryer
will re-set itself after being left to cool for a few minutes, but please check air inlet and
outlet grills are clear before continuing to use the dryer.
OPERATING INSTRUCTIONS
Switch position
0 = Off
1 = hot air / low air flow
2 = very hot air / strong air flow
* = lukewarm air
= TURBO button
Accessories
1 Retractable combs thermal brush for tangle free waves & curls, Ø 22 mm
1 Thermal bristles with massaging bristles for volume & shine, Ø 25 mm
1 air concentrator
Applying/changing accessories
Fit the accessory on the unit so that the reference marks
►◄ correspond, and push until a
click is heard.
To remove or change an accessory pull it out of the unit holding the locking button down.
OPERATING TIPS:
1. Before using this unit, wash your hair and towel dry.
2. Plug the unit into the power supply socket.
3. Dry your hair using this unit without any accessories, before adding shape using the
brushes.
4. Hair that has just been washed and dried can be styled better.
5. The first few times you use this unit it is advisable to practice on small areas of your
hair.
USING THE VARIOUS ACCESSORIES
• Retractable combs thermal brush for tangle free waves & curls, Ø 22 mm
This is designed to create curls and waves quickly. In addition, the metal coating means
that the hair style stays in place longer. To style your hair using this accessory - With the
unit off make the bristles stick out of the metal casing by turning the ring nut at the top of
it clockwise until it stops turning. Then wind a lock of hair around the brush, starting from
the ends and working towards the roots. Switch the unit on and briefly heat your hair,
putting the switch in position 1 or 2. For better hold, let the locks cool in position * for a
few seconds. To release your hair the lock need not be unrolled, simply turn the ring nut
at the end of the brush anticlockwise to retract the bristles into the metal casing. Then pull
the brush out of the curl.
00060579 Turbo Style 1000 Tourmaline lug2013:Layout 1 04/