English – Remington BHT2000 User Manual

Page 6

ENGLISH

REMOVING THE SHAVER COVER (Diagram G)

Gently push the buttons either side of the shaving foil. With the other hand lift the

shaver cover. Clean then replace.

REPLACING THE CUTTER ASSEMBLY

Hold the Trimmer in one hand. With your other hand, insert the lower part of the

cutter assembly into the Trimmer, push down the cutter until firmly attached.

REPLACING THE TRIMMER COMB AND SHAVER ATTACHMENT

(Diagram H)

Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel to keep

it from turning. Ensure that the Length Position Indicator is at 1.

Slide the comb/shaver down the grooves until it clicks into place.

NOTE: The trimmer comb and shaver attachment can only be attached in one way.

If it does not go on correctly, turn it around and try again.

REPLACING THE FOILS & CUTTERS

To ensure the continued highest quality performance from your shaver, we recommend that
the foil and cutter are replaced regularly.

Signs that your foils and cutters need replacing:

1. Irritation: As foils get worn, you may experience skin irritation.
2. Pulling: As the cutters wear, your shave may not feel as close and you may feel your

cutter pulling your hair.

3. Wear through: You may notice that the cutters have worn through the foils.

Replacement cutters and foils available. Model: SP02.

CARE FOR YOUR TRIMMER

Care for your product to ensure a long lasting performance. We recommend you clean your
shaver after each use. The easiest and the most hygienic way to clean the shaver is by rinsing
the product head after use with warm water. Always keep the trimmer in the “off” position
when not in use.

AFTER EACH USE

Turn Trimmer off.
Remove the adjustable trimmer comb and cutter assembly or shaver attachment.
Gentle tap on a flat surface to remove hair particles, and brush the remaining hairs

away/rinse under warm water (Diagram I).

CLEANING CAUTIONS

Only the adjustable trimmer comb and cutter assembly may be removed from the

Trimmer for cleaning.

080706_REM_IFU_BHT2000_22L.indd GB4

05.11.2008 12:21:48 Uhr