Remington HC5780 - Manual (Page 8)

8
ENGLISH
F IMPORTANT SAFETY INSTRUCTIONS
Warning – To reduce the risk of burns, electrocution, fire, or injury to persons:
• Do not leave the appliance unattended while plugged in.
• Only set the appliance down on a heat-proof surface.
• Make sure the power plug and cord do not get wet.
• Do not plug or unplug the appliance with wet hands.
• Do not use the appliance if it is damaged or malfunctions.
If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
• Do not twist or kink the cable, and don’t wrap it around the appliance.
• Store the product at a temperature between 15°C and 35°C.
• Do not use accessories or attachments other than those we supply.
• The appliance, including its cord, must not be used, played with, cleaned or maintained
by persons under eight years old and should at all times be kept out of their reach.
Use, cleaning or maintenance of the appliance by children over eight or by anyone with a
lack of knowledge, experience or with reduced physical, sensory or mental capabilities
should only be undertaken after receiving appropriate instruction and under the
adequate supervision of a responsible adult to ensure that they do so safely and that the
hazards involved are understood and avoided.
• Don’t put the appliance in liquid, don’t use it near water in a bath-tub,
basin or any other vessel, and don’t use it outdoors.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in
electrical and electronic goods, appliances marked with this symbol must not
be disposed of with unsorted municipal waste, but recovered, reused or recycled.
^ BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• Ensure the clipper is discharged of all power and disconnected from the mains.
• Lift or pry the USB port cover plate on the bottom of the clipper.
• Lift or pry the deco plate on the lower portion of the clipper and unscrew 1 screw located
on the back housing of the clipper.
• Lift or pry the clipper halves apart, exposing the battery chamber.
• Lift or pry the USB connector and lift or pry the cover plate on the bottom of the battery
chamber.
• Take out the battery and printed circuit board assembly from the battery chamber.
• Cut the tabs on both ends of the battery and remove it from the printed circuit board
• The battery is to be disposed of safely.
HC5780 -INT-T22-amended.indd 8 11/19/2012 12:09:36 PM