Candy TR 31 RUFA - Manual (Page 11)

CHANGING THE GAS TYPE GLASS / VITROCERAMIC HOB
10 GB
JETS
Propane Gas
G31 37 mbar Burner Natural Gas
G20-20 mbar
G25-25 mbar Butane Gas
G30 28-30 mbar
R (3 kW)
SR (1,75 kW)
130
100
86
67
86
67
Jet
Burner’s body
(top view)
Fast Burner Semi-Fast Burner
By-pass screw for the hob burner
Never loosen
other screws!
• CHANGING THE JETS
Each jet is designated by size.
To gain access to the jets :
• remove the pan supports,
• remove the burner cap and body,
• using a pipe spanner, unscrew the jet,
• fit the correct jet for the type of gas to be used,
• secure the jet tightly,
• regulate the air ring,
• replace the burner body, cap and the pan support.
• REGULATE THE FLAME
If you have changed the type of gas, it is important to verify the flame stability
at the minimum regulation.
To gain access to hob burner by-pass screws, remove the knobs from the
control panel.
a) Natural gas :
• simply loosen the screw.
• switch on the burner and turn the knob to minimum.
• Turn the by-pass screw until a low flame is visible. Turn the control knob
from minimum to maximum position to check that it is satisfactory.
b) Butane-propane gas :
The by-pass screw should be screwed fully home, without being locked.
The appliances are regulated by the manufacturer for the type of gas indicated on the packing and on the label attached to the
appliance itself. If they are to be used with another type of gas, the appliance must be adjusted in the following way: