Candy FO 2D 468 X - Manual (Page 13)

13
• PRELIMINARY CLEANING - clean the oven before using for the first
time:
. wipe over external surfaces with a damp soft cloth.
. Wash all accessories and wipe inside the oven with a solution
of hot water and washing up liquid.
. Set the empty oven to the maximum temperature and leave on
for about 1 hour, this will remove any lingering smells of
newness. Ensure that the room is well ventilated while this is
being done.
• THINGS TO REMEMBER
Confirmation of operation: modification must be confirmed by
pressing the central button.
Stopping the oven: this may be necessary if you have input an
incorrect instruction.
To stop the oven .... turn back the function selector knob to the
Stop Position.
Child safety device: To lock the oven controls, select the child
safety device. Refer to the section entitled "Programming - The
child safety device".
The cooling fan: this protects the control panel and electronics
from heat damage.
It begins and then stops automatically even when the oven is
switched off.
Oven lighting: By turning to the light symbol, you can switch on
the oven light when it is not in use.
When the oven is in use, the light stays on during all of the oven
functions and when the door is opened.
CONTROL PANEL DESCRIPTION
ADVICE BEFORE USING THE OVEN FOR THE FIRST TIME
DESCRIPTION OF THE DISPLAY
• CLOCK SETTING
When the oven is connected to the electricity supply or after a long
power cut, the clock must be re-set.
. To set the clock :
1-Turn the control knob to the "Clock" symbol.
2-When the minutes flash, set the central button by turning to the
"-" or "+" symbol. Confirm by pressing the central button.
3-The hours will then flash, set with the central button by turning
to the "-" or "+", confirm by pressing the central button.
4-Turn back the control to the STOP position, the new hour is
set.
• LANGUAGE CHOICE
The pre-set language setting on the display panel is in Italian, but it
can be changed to Spanish or English.
To change the language display, carry out the following procedure :
1- Turn the programme selector knob to "Light" symbol.
2- Press the central button in and hold for 3 seconds. The display
panel will show ITALIANO. Turn the button until the required
language appears and confirm by pressing the same button.
The display will disappear.
3-Your selection is now confirmed. Turn the programme selector
knob back to the STOP position.