VDO Z3 PC - Manual (Page 41)

32
EN
through)
‚ „ NAVIGATOR NEXT DIGIT
... repeat for all digits from back to front
‚ NAVIGATOR ?SET OK?
∂ ƒ Set first digit (keep button depressed for fast run-
through)
‚ NAVIGATOR SET DONE
Automatic return to the operation mode for NAVIGATOR
12.2. RESETTING THE NAVIGATOR AT THE ORIENTATION POINT
3 sec.
√ TRIP DATA ?RESET?
∂ ƒ NAVIGATOR ?RESET?
‚ NAVIGATOR ?RESET? <
>> flashes
‚ NAVIGATOR RESET DONE
Automatic return to the operation mode for NAVIGATOR
Navigator reset done
13. THE TIMING FUNCTIONS
The following settings are of particular importance when using the
pulse functions (chapter 14).
Your VDO computer has 6 different timing functions. If one of the timing
functions is running the TIMING indicator icon will always be flashing
in the left part of the display. Moreover the residence times in the trai-
ning ranges are captured for each running timing function (see chapter
Kap. 14). The setting range/measuring range for all timing functions is
0:00:00 h to 24:00:00 h
TIMER 1: You can program a time e.g. for interval training. TIMER 1
counts from zero forward. At the end of TIMER 1 there is a single beep.
Timer 1 only functions if you have set a time. If you have forgotten to
set a time your VDO computer displays TIMER ERROR
TIMER 2: You can program a time, e.g. for the rest phase in an interval
training. TIMER 2 counts from zero forward. At the end of TIMER 2 there
are two beeps. Timer 2 only functions if you have set a time. If you have
forgotten to set a time your VDO computer displays TIMER ERROR
TIMER 1+2 runs until you stop these functions. Timers 1 + 2 only
function if you have set a time. If you have forgotten to set a time your
VDO computer displays TIMER ERROR.
COUNTDOWN: You can program a time, the timer will count backwards
from this time. At the end of the COUNTDOWN time there is a single
beep. Countdown only functions if you have set a time. If you have
forgotten to set a time your VDO computer will display COUNTDOWN
ERROR.
LAP TIMER: Start Lap Timer with ∫ . Start next Lap with ≈ + ¥ at the
same time at any point of the training unit. The following values will
be saved: