VDO Z3 PC - Manual (Page 31)

22
EN
8.1. SETTING THE HOME ALTITUDE (STARTING ALTITUDE)
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ HOME ALTI SET
‚
∂ ƒ Setting the home altitude
‚ HOME ALTI ?SET OK?
‚ HOME ALTI SET DONE
Automatic return to the operation mode for ALTI UP. The set home
altitude will be displayed as actual altitude. Home altitude set done
Re-calibrating the air pressure to home altitude. Important: Prior to
each trip the actual measured pressure must be calculated back to the
set home altitude = re-calibrate. Short-cut press the ¥ button for 4
seconds.
8.2. SETTING THE ACTUAL ALTITUDE
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ ACTUAL ALTI SET
∂ ƒ Setting the actual altitude
‚ ACTUAL ALTI ?SET OK?
‚ ACTUAL ALTI SET DONE
Automatic return to the operation mode for ALTI UP. Actual altitude set
done
8.3. ANNUAL UPHILL ALTITUDE GAIN BIKE 1 AND BIKE 2 AND WALK
MODE
Your VDO computer accumulates values for the meters in altitude for
the uphill gain covered separately for:
- Bike 1
- Bike 2
- Walk mode (see chapter 10 for selection)
These values can be programmed in, if for example you want to trans-
fer the values from an older device, or if the values have been deleted
when changing batteries.
Setting the annual uphill gain in altitude
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ ALTI UP SET
‚ ALTI UP 1 SET (for bike 2 or walking
ƒ ALTI UP 2 SET / WALK UP SET)
‚ ALTI UP 1 NEXT DIGIT/ ALTI UP 2 NEXT DIGIT / WALK
UP NEXT DIGIT
∂ ƒ Set last digit (keep button depressed for fast
run-through)
‚ ... repeat for all digits from back to front
‚ ALTI UP 1 ?SET OK? / ALTI UP 2 ?SET OK?
/ WALK UP ?SET OK?
∂ ƒ Setting the first digit
‚ ALTI UP 1 SET DONE / ALTI UP 2 SET DONE
/ WALK UP SET DONE
Automatic return to the operation mode for TOTAL UP. Annual uphill
altitude gain set done.
8.4. ANNUAL DOWNHILL ALTITUDE LOSS BIKE 1 AND BIKE 2 AND WALK
MODE
Setting the annual downhill altitude loss
3 sec.
ç Setting mode LANGUAGE SELECT
HOME
AL TITUDE