Plantronics CS530 - Manual (Page 20)

20
Place an outgoing call
1 Wearing your headset, press the headset call control button.
2 Remove the handset from the cradle. You will hear a dial tone.
NOTE This step will be automatic if you install a lifter or EHS cable accessory. For a complete list of
accessories, visit plantronics.com/accessories.
3 Dial the number using your desk phone.
4 To end the call, press the headset call control button and hang up the handset.
Answer an incoming call
1 Wearing your headset, press the headset call control button.
2 Remove the handset from the cradle speak to your caller.
NOTE This step will be automatic if you install a lifter or EHS cable accessory. For a complete list of
accessories, visit plantronics.com/accessories .
3 To end the call, press the headset call control button and hang up the handset.
Conference up to three additional headsets
You can conference up to three additional headsets to a call in progress.
Join a conference call
While the base has an active link (on a call), place the guest headset into primary user’s charge
cradle (this connects the headset to the base). When the base subscription LED stops flashing
white and becomes solid white, the primary headset/user will hear a tone indicating a guest
wishes to join the call. Press the primary user’s call control button to accept the guest headset
within ten seconds or the request is terminated and the guest will hear an error tone in their
headset.
To connect a guest headset that is of different variety than the primary headset briefly press
the base subscription button while the base has an active link. Next, press the guest headset
volume up button until the indicator light turns on. When the base subscription LED stops
flashing white and remains solid white, the request to join will be heard in the primary user’s
headset and the primary user will have to press their call control button within 10 seconds to
accept the guest
Exit a conference call
Guests headsets can remain as guests through multiple calls. To remove a guest headset, press
the guest headset’s call control button or dock the primary user’s headset in the charge cradle.
A single tone in the master headset will be heard as each guest leaves the call.
Daily use