beautypg.com

Your base – Plantronics CS530 User Manual

Page 18

background image

18

Base phone button and switches

1 Subscription button

The headset and base that came in the box are subscribed (connected) to each other. However,
if you wish to use a new headset or need to restore subscription to your current headset, the
units can be subscribed to each other by the following two methods.

Automatic secure subscription

With your system idle, docking a headset will automatically subscribe it to the base, making
it the primary headset. The Power On/Subscription LED will flash white during subscription
process and become solid white when the new subscription is established.

Manual over-the-air subscription

1

With your system idle and your headset undocked, press and hold the subscription button on

the base for three seconds. The Power on/subscription light will flash white.

2

Press and hold the volume up button on the headset for three seconds until the headset LED
turns solid white. When the Power on/subscription LED on the base becomes solid white, the
headset and base are subscribed to one another.

NOTE

If the subscription process times out after two minutes or if the subscription process fails,

the subscription LED on the base will go dark for three seconds and then re-illuminate steadily to
indicate power is applied to the base.

If this occurs, try to re-subscribe the headset again.

Ending subscription

If the base is in subscription mode and you want to stop the base from searching for a headset,
press the subscription button again. The subscription LED on the base will go dark for three
seconds and then re-illuminate steadily to indicate power is applied to the base.

Power on/Subscription LED

Base Status

Power On/Subscription LED

Primary headset subscription

Flashes white

Primary headset subscribed to base

Solid white

Conference call headset subscription

Flashes white

Active conference call with guest headsets

Flashes white

1

2

3

Your base