HONDA 2008 Accord Navigation - Manual (Page 40)

40 Navigation System
By Map Input
After you select Map Input from the
MENU screen (Enter destination by),
the display changes to:
NOTE:
• Prior to departure, you can set areas
to avoid. The system then includes
them in its calculations for the
destination you have entered. See
Edit Avoid Area on page
90 .
• For information on the available
voice commands, see Voice
Command Index on page
132 .
Showing the Map of Current
Position
The Current Position selection
assumes that you are looking for a
destination in the immediate area. The
display changes to:
The red arrow indicates your vehicle
position. Find your desired destination
by moving the Interface Dial left,
right, up, or down. The map and cross
hairs will move in the same direction.
If desired, rotate the Interface Dial
knob to change the map scale. When you
have the cross hairs in the desired icon,
map feature, or road, push in on the
Interface Dial. The address of the
location will appear at the top of the
screen.
The yellow box indicates the area you
will see when you click on the current
map with the Interface Dial.
NOTE:
The selected icon or road segment is
displayed on the 1/2 mile (800 meter) or
less map scale.
If this is the desired address, push in on
the Interface Dial again. If not, use the
Interface Dial to reposition the cross
hairs, then push in on the Interface
Dial again to display the new address.
If you select a single icon or road
segment within the targetmark, the
following screen appears. Select Set as
Dest. to calculate a route to the selected
destination.
Entering a Destination
2008 Accord
Main Menu