HONDA 2013 Fit - Manual (Page 249)

uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
248
Han
d
lin
g the U
n
expected
13. Unscrew the sealant/air hose from the tire
valve stem. Reinstall the valve cap.
14. Push the deflate button until the gauge
returns 0 psi.
15. Apply the wheel label to the flat surface of
the wheel.
u The wheel surface must be clean to
ensure the label adheres properly.
1. Apply the speed limit label to the location
as shown.
2. Drive the vehicle for about 5 minutes.
u Do not exceed 50 mph (80 km/h).
3. Stop the vehicle in a safe place.
Air Pressure Gauge
Deflate Button
Wheel Label
■
Distributing the Sealant in the Tire
1 Injecting Sealant and Air
If the required air pressure is not reached within 15
minutes, the tire may be too severely damaged for
the kit to provide the necessary seal and your vehicle
will need to be towed.
Keep the empty bottle after the sealant is injected.
The sealant bottle will be used to collect the injected
sealant by a professional.
1 Distributing the Sealant in the Tire
Stop and recheck the air pressure after every 5
minutes of driving as necessary until you reach the
nearest service station where you should have the tire
permanently repaired or replaced.
Speed Limit Label
2013 Fit
TOC
Home
QRG
Index