HONDA 2011 Civic Coupe - Manual (Page 322)

Open the trunk.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Remove the screw in the center of
the fastener on the side of the
trunk lining. Pull the lining back.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Put the fastener into the hole on
the side of the trunk lining.
Reinstall the screw.
Determine which of the four bulbs
is burned out: stop/taillight,
back-up light, side marker light, or
turn signal light.
Remove the socket by turning it
one-quarter turn counterclockwise.
1. 2.
3.
4.
5.
6.
7.
8.
Replacing Rear Bulbs
Lights
316
FASTENER
10/06/24 17:03:16 31SVA650_321