Plantronics HL10 - Manual (Page 5)

ENGLISH FRANÇAIS
ESP
AÑOL
POR
TUGUÉS
3
Q UICK START GUIDE
The HL10 Handset Lifter accessory is designed to auto-
matically lift most standard telephone handsets off the
cradle when activated by your Plantronics amplifier.
Use the numbered illustrations in the centre of this
guide. The centre section may be pulled out for easier
reference and use.
1. Identify Lifter Parts
See reference number 1 on illustration
(Top view of the lifter on a telephone)
1.1 Motor Housing
1.2 Lifting Pad
(Back and underside view of lifter alone)
1.3 Lifter Height Switch (low, medium, or high)
1.4 Accessory Jack
1.5 Mains Lead (non-removable)
2. Position and Test Lifter
See reference number 2 on illustration
Note: Do not remove the mounting tape backing until
directed to do so.
2.1 Plug the mains lead into your Plantronics amplifier
accessory jack and position the lifter under your tele-
phone handset towards the earpiece. You may need to
position the lifter slightly differently for optimal lifting.
Tip: Remove only a tiny piece of the mounting tape backing
to temporarily stick the lifter into a test position.
2.2 Use the three-position lifter height switch to adjust the
lifter to its optimum height. Test the lifter‘s position by