TP-Link TL-WR940N - Manual (Page 54)

300Mbps Wireless N Router TL-WR940N/TL-WR941ND
-46-
¾ DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network or else you must configure the computer
manually.
¾
Start IP Address - Specify an IP address for the DHCP Server to start with when assigning
IP addresses. 192.168.0.100 is the default start address.
¾ End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP
addresses. 192.168.0.199 is the default end address.
¾
Address Lease Time - The Address Lease Time is the amount of time a network user will
be allowed connection to the router with their current dynamic IP Address. Enter the amount
of time in minutes and the user will be "leased" this dynamic IP Address. After the time is up,
the user will be automatically assigned a new dynamic IP address. The range of the time is 1
~ 2880 minutes. The default value is 120 minutes.
¾
Default Gateway - (Optional.) Suggest to input the IP address of the LAN port of the router,
default value is 192.168.0.1
¾
Default Domain - (Optional.) Input the domain name of your network.
¾
Primary DNS - (Optional.) Input the DNS IP address provided by your ISP. Or consult your
ISP.
¾
Secondary DNS - (Optional.) Input the IP address of another DNS server if your ISP
provides two DNS servers.
)
Note:
To use the DHCP server function of the router, you must configure all computers on the LAN as
"Obtain an IP Address automatically" mode.
4.7.2 DHCP Clients List
Choose menu “DHCP→DHCP Clients List”, you can view the information about the clients
attached to the router in the next screen (shown in Figure 4-27).
Figure 4-27 DHCP Clients List
¾
ID - The index of the DHCP Client
¾
Client Name - The name of the DHCP client