Eizo FlexScan HD2441W - Manual (Page 10)

8
English
Troubleshooting Setting/Adjustment Prior to use Installation
Connecting Cables
1
Check that the monitor is powered off.
2
Connect a PC.
Attention
• When replacing the current monitor with an HD2441W monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the HD2441W monitor referring to
the resolution table (see page 3) before connecting the PC.
1. Check that the PC is powered off.
2. Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Macintosh Windows
Macintosh Windows
Connectors on the
PC
DVI connector
D-Sub mini 15-pin
connector
Connectors on the
monitor
Signal cable FD-C39 (supplied)
Signal cable MD-C87 (supplied)
Digital connection
Analog connection
DVI-D connector
D-Sub mini 15-pin
connector