Eizo FlexScan SX3031W - Manual (Page 8)

6
English
Prior to use Installation Setting/Adjustment Troubleshooting
No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.
1. Check the Power indicator.
Symptom Status Possible cause and remedy
No picture Power indicator does not light
up.
• Check whether the power cord is correctly
connected.
• Press .
Power indicator lights blue. Switch the input signal with .
Power indicator lights orange. Press a key on the keyboard or click the mouse.
Turn on the PC.
Either SIGNAL1 or SIGNAL2 may have an error
in dual display mode.
Check that in (Refer to the User’s
Manual on the CD-ROM).
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom Status Possible cause and remedy
[Single Display]
[Dual Display] *
The input signal is not received. Check whether the PC is turned on.
Check whether the signal cable is properly
connected to the PC.
Switch the input signal with
. (Single display
mode only)
[Single Display]
[Dual Display] *
The signal frequency is outside
the specification. Incorrect
signal frequency is shown in
red.
Change the mode to an appropriate mode using
the graphics board’s utility software. Refer to the
manual of the graphics board for details.
* In dual display mode, the error message appears only when both of SIGNAL1 and SIGNAL2 have errors.