beautypg.com

Connecting cables – Eizo FlexScan SX3031W User Manual

Page 5

background image

3

English

Troubleshooting

Setting/Adjustment

Prior to use

Installation

Connecting Cables

Attention

• When replacing the current monitor with a SX3031W-H monitor, be sure to change the PC settings for

resolution and vertical frequency to those which are available for the SX3031W-H monitor referring to the

resolution table (back of cover page) before connecting the PC.

1

Check that the monitor and the PC are powered off.

2

Connect the monitor to the PC with a signal cable that matches the connectors.

After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.

• When the resolution of the graphics board on your PC is applicable to 2560 × 1600 (Single display);

Connectors on the

PC

DVI connector

Connectors on the

monitor

SIGNAL1

Signal cable DD200DL-BK (supplied)

• When the resolution of the graphics board on your PC is not applicable to 2560 × 1600 (Dual display);

Dual display (simultaneous left and right sides display) is available by using a dual DVI-D system graphics

board or any two graphics boards.

Dual display with 1280 × 1600 resolution is the maximum display size.

DVI connector

SIGNAL1

Signal cable DD200DL-BK (supplied)

Connectors on the

PC

Connectors on the

monitor

DVI connector

SIGNAL2

Signal cable FD-C39 (supplied)

3

Plug the power cord into a power outlet and the Power connector on the monitor.