Swarovski Optik Z6(i) 5-30x50 P (BT) - Manual (Page 10)

19
DE
18
DE EN EN
the scope has been filled with nitrogen via the sealing
screw located underneath the windage adjustment
turret. Please do not loosen this sealing screw!
mounting
Basic alignment
to ensure perfect alignment of the scope to the
rifle, please have a competent gunsmith mount the
scope.
the reticle has been factory-set to the mechanical
middle position. Prior to mounting you can check the
correct position of the reticle. to do this, unscrew the
screw-on caps of the elevation adjustment turret and
windage adjustment turret.
Now turn the respective knurled knob of the eleva-
tion adjustment turret and windage adjustment turret
clockwise until it reaches the stop. then turn the
knurled knob back again counter-clockwise until it
reaches the stop and count the clicks at the same
time.
Halve the number of clicks and you will have the
exact middle position. repeat this procedure for the
second turret.
alignment of the Scope to the rifle
if the point of impact of the bullet deviates from the
aiming point, this can be easily and precisely correc-
ted by adjusting the elevation turret and the windage
turret of the scope.
regardless of corrections, the middle point of the
aiming mark always stays in the middle of the field
of view.
to make adjustments, simply unscrew the screw-on
caps of the elevation and windage turrets.
When the shot is low
turn the knurled
knob of the elevation
turret in the direction
of H (counter-clock-
wise).
When the shot is high
turn the knurled
knob of the elevation
turret in the opposite
direction to H (clock-
wise).
When the shot is to the left
turn the knurled
knob of the windage
turret in the direc-
tion of r (counter-
clockwise).
When the shot is to the right
turn the knurled
knob of the windage
turret in the opposite
direction to r (clock-
wise).
the impact point correction per click can be taken
from the enclosed technical data sheet or the infor-
mation printed on the elevation or windage adjust-
ment turret of your rifle scope.
Zero point adjustment
once you have aligned the scope to the rifle, you can
retain this basic setting. the scale for this is located
on the respective knurled knob of the elevation/
windage adjustment turret.