SoundMax SM-CDM1066 User Manual
Page 7
7
REAR-MOUNT (Method B)
thod, use the screw holes in the lateral sides of the unit. Fix the unit with the help of the
mounting brackets.
ect a position in which the screw holes of the brackets (3) are aligned with
the screw holes in the unit body, and screw in two screws (2) in each side.
2. Screw.
3. Factory radio mounting brackets.
4. Vehicle dashboard.
5. Lock (remove this part).
Note: The outer trim frame and mounting sleeve are not used for method of
installation.
Installing the front panel
Insert the right side of the panel then, and insert the left side. Lift the upper part of the panel and press it
until a click to close the panel.
Press OPEN button to detach the panel. When the front panel is flipped-down, lift it to a little angle from
horizontal position, then push the panel leftwards to release the right part. Then release the left part and pull
the panel out.
Anti-theft system
The front panel of this unit can be stored in the included protective case when not in used and carried away
when you leave the vehicle to deter theft.
Switch off the power of the unit. Detach the front panel, then put it to the protective case and take it with
you.
Cautions: The control panel can easily be damaged by shocks. After removing it, place it in a protective case
and be careful not to drop it or subject it to strong shocks.
The rear connector that connects the main unit and the control panel is an extremely important part. Be
careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.
Note: If the control panel is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in
isopropyl alcohol to clean the socket on the back of the control panel.