Skil 0715 RT - Manual (Page 8)

8
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.,
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a hazardous
situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
SPECIFIC SAFETY INSTRUCTIONS FOR LAWN
MOWERS
EXPLANATION OF SYMBOLS ON TOOL
④ Read the instruction manual before use
⑤ Double insulation (no earth wire required)
⑥ Pay attention to the risk of injury caused by flying
debris (keep bystanders a safe distance away from
work area)
⑦
Beware of sharp blades
⑧ Keep the (extension) cord away from the rotating cutting
blade
⑨ The cutting blade continues to rotate for a short time
after tool is switched off (do not touch rotating blade)
⑩ Switch off and disconnect plug before cleaning/
maintenance or if (extension) cord is damaged or
entangled
⑪ Do not dispose of the tool together with household
waste material
GENERAL
• Avoid operating the mower on wet lawns
• The user is responsible for accidents or hazards
occurring to other people or their property
• Never operate the tool with a defective rear guard or
defective grass box
• When operating the tool without grass box, ensure
that the rear guard is in closed position (risk of injury
caused by rotating cutting blade)
• Always disconnect plug from power source
- whenever leaving the tool unattended
- before clearing jammed material
- before checking, cleaning or working on the tool
- after striking a foreign object
- whenever the tool starts vibrating abnormally
ELECTRICAL SAFETY
• Inspect the cord periodically and have it replaced by a
qualified person, if damaged
• When operating the tool use a residual current device
(RCD) with a triggering current of 30 mA maximum
• Use completely unrolled and safe extension cords with a
capacity of 16 Amps (U.K. 13 Amps)
• Only use an extension cord of types H05VV-F or
H05RN-F which is intended for outdoor use and
equipped with a watertight plug and coupling-socket
• Do not run over, crush or pull the (extension) cord
• Protect the (extension) cord from heat, oil and sharp
edges
• Inspect the extension cord periodically and replace it,
if damaged (inadequate extension cords can be
dangerous)
PERSONAL SAFETY
• Do not operate the tool when barefoot or wearing open
sandals; always wear sturdy shoes and long trousers
• Be familiar with the controls and the proper use of the
tool
• Never mow in the direct vicinity of persons (especially
children) and animals
• Always keep hands and feet away from rotating
parts
• Keep away from the discharge opening at all times
• Switch on the motor according to instructions and with
feet well away from the cutting blade
• This tool is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
tool by a person responsible for their safety (local
regulations can restrict the age of the operator)
• Ensure that children do not play with the tool
• Operate the mower at a walking pace only (do not run)
• Keep proper footing on slopes and do not mow
extremely steep slopes
• Be extremely careful when moving backwards or pulling
the mower towards you
BEFORE USE
• Check the functioning of the tool before each use and,
in case of a defect, have it repaired immediately by a
qualified person; never open the tool yourself
• Thoroughly inspect the area where the mower is to be
used and remove all hard objects which could be caught
up and thrown by the cutting mechanism
• Always ensure that the cutting mechanism is in good
working order (have worn or damaged parts replaced)
• Keep all nuts, bolts and screws tight to be sure that the
mower is in safe working condition
DURING USE
• Only mow with sufficient daylight or with appropriate
artificial lighting
• Do not tilt the tool when starting or switching on the
motor, except if the tool has to be tilted for starting
in long grass (in this case, do not tilt it more than
absolutely necessary and tilt only the part which is away
from the operator); always ensure that both hands are
in the operating position before returning the tool to the
ground