SUUNTO Vyper Air - Manual (Page 24)

ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
SELECT TANK
PRESSURE ON.
5.9. Activation and pre-checks
This section describes how to activate the DIVE mode and explains the pre-checks that
it is highly recommended you perform before you get into the water.
5.9.1. Accessing DIVE mode
The Suunto Vyper
AIR
has three diving modes: AIR mode for diving with standard air only,
NITROX mode for diving with oxygen enriched mixtures, and GAUGE mode for use as a
bottom timer and for freediving.
The OFF mode disables the DIVE mode, and allows the TIME mode to be used underwater.
The chosen dive mode is displayed when the DIVE mode is accessed, and you can toggle
between the submodes by pressing the UP/DOWN buttons.
5.9.2. DIVE mode activation
The dive computer activates automatically when submerged deeper than 0.5 m/1.5 ft.
However, it is necessary to activate the DIVE mode BEFORE diving to check the
altitude and personal adjustment settings, battery condition, oxygen settings etc.
After activation, all graphical display elements are turned on, and the backlight and the
beep are activated. After this, the selected altitude and personal settings are displayed,
as well as the RGBM and Deep Stop status. A few seconds later the battery power indicator
is shown.
At this time, perform your pre-checks, making sure that:
•
the instrument operates in the correct mode and provides a complete display
(AIR/NITROX/GAUGE mode)
• the battery level is ok
• the altitude, personal adjustment, Safety/Deep stops, and RGBM settings are correct
• the instrument displays correct units of measurement (Metric/Imperial)
• the instrument displays the correct temperature and depth (0.0 m/0 ft)
• the alarm beeps
If the optional wireless pressure transmitter is used ensure that:
•
the pressure transmitter has been properly attached and the cylinder valve is open
• the transmitter and the wrist unit have been properly paired on a suitable code
24