Hama VS270 - Manual (Page 4)

2
VS270 / EN - rst - fr - es / epheme - rst / 06-2006
Principles of operation
If you already have a Thomson plasma screen monitor or video projector, the Video Sender will
ease your placing of these items where you most want them to be, thanks to eliminating all
problems related to long cable runs.
1. Connect the transmitter SCART connector
to the main SCART socket (AV1, EXT1,
AUX1, etc.) of the appliance whose images
you want to view (DVD, satellite, VCR, etc.). If
the appliances are connected to one another,
select the appliance that is used most often.
2. Connect the SCART connector of the recei-
ver to a SCART socket on the TV.
3. Switch on the transmitter and the receiver
by pressing the ON buttons.
4. Make sure that the transmitter and the
receiver are set to the same channel by
checking the position of selectors A, B,
C, D. They must be set to the same chan-
nel (same letter).
5. Switch on your equipment (television sets,
video recorders ...) in both rooms.
6. On the screen, select the SCART input
that is connected to the receiver.
Special operating details:
No picture on TV2? If you fail to obtain the
desired picture on the second television set
TV2, select the AV socket, to which the recei-
ver (2) is connected, using the television’s
remote control.
Using a decoder (in France: Canal +, TPS, etc.)
on your TV2? To have clear images on your
second TV set (TV2), output from the deco-
der must pass through a VCR player, placed
in (AV2) mode or set to the channel number
assigned for the encrypted TV channel. (Refer
to the booklet of the concern equipment).
Use of a monitor? If your second television
set does not have a connection for an out-
side aerial (terrestrial reception), or if it is a
monitor, you will be able to see the channels
in the room containing the second television
set by selecting those of the video recorder
with its remote control.
The picture is scrambled? The running of
certain equipment (micro-wave ovens, digi-
tal telephone DECT, un-shielded acoustic
loudspeakers, etc ...) may interfere with signal
transmission. Ensure that they are kept away
from the transmitter and the receiver or
switch them off.
Improvement of picture and
sound
If no picture is obtained, check that the
transmitter and the receiver have not been
installed in the reverse order (each unit
corresponds either to the input or to the
output of the Audio-Video signal). Check that
they have been properly connected and that
they are switched on ( ON). Ensure that the
channel selector is set to the same letter on
both units.
If transmission is blurred or scrambled,
choose another channel but make sure that
it is identical on both units.
Installation of transmitter Installation of receiver
Instructions for use
01_VS270_EN.indd 2 01_VS270_EN.indd 2 29/06/06 12:01:10 29/06/06 12:01:10