Hama MW1002 User Manual
Page 39

GB
39
MW-1002
CAUTION
The sensor may be damaged if the alcohol
concentration is too high.
Using alcohol with a high concentration may cause
damage to the sensor.
Always use alcohol with a concentration of 3-5%.
►
Start the sensor cleaning process according to the
chapter entitled “Changing the settings”.
If OFF appears in the display, press the “+/ ” button [7].
ON appears in the display.
Press the SET [8] button to activate the selected
cleaning process.
The cleaning process should stop automatically after 10
minutes. ASC flashes on the display throughout the entire
cleaning process [1]. The device beeps three times two
minutes before the end of the cleaning process. After the
cleaning process is complete, the device beeps once and
the time is shown in the display.
NOTE
The cleaning process can be cancelled at any time
by pressing the MODE button once.
►
u
u
u
00087697bda_neu.indd 39
00087697bda_neu.indd 39
03.08.2009 9:58:15 Uhr
03.08.2009 9:58:15 Uhr