Edimax Technology EW-7722UnD - Manual (Page 50)

47
7. Sometime WPS may fail (In the following picture, WPS pairing is failed because no
WPS-enabled access point is found):
Y ou can click „PBC‟ button few more times to try again. When an access point is
connected, you can click „Disconnect‟ to disconnect your wireless network card from a
connected access point, or select another WPS-enabled wireless access point, then
click „Connect‟ to establish connection to selected access point, if there are more than
one WPS-
enabled access point found. You can also click „Rotate‟ button, and next
access point on the list will be selected to establish connection.
If you want to delete a found access point from the list, select it and click „Delete‟ button.