Edimax Technology IC-9000 User Manual

Page 13

1-5 Install the IC-9000

There are only three things that you need to do to see the video from the IC-9000:

1. Connect the IP CAM to the home/office network.

2. Install the CamView software on the notebook/PC.

3. Key in the ID/password of the IP CAM(from the ID/Password card) on the CamView, and

then you can see the video.

1-5-1 Hardware Installation

Please follow the following instructions to set up the IC-9000:

1. Please connect the IP CAM accessories to the body of the IC-9000 correctly, including

the bracket, power adapter and Ethernet cable, as shown in the above figure.

2. Connect the other end of the Ethernet cable to the home network or office network.

Usually, this Ethernet cable is plugged into a home NAT/router device or an Ethernet

switch if in the office, as shown in the above figure.

3. Since the default settings of the IP CAM use DHCP function and very often there is a

DHCP server on most of the Home/office network, the IP CAM should be connected to

the Internet immediately