Edimax Technology CV-7438nDM - Manual (Page 36)

36
progress of the restore and you will see a
confirmation screen when the reset is
complete.
After restoring to the bridge to factory defaults, you will need to
connect to the “EdimaxCV.setup” SSID again and setup the
wireless bridge. See
II. Installation.
You can also restore the wireless bridge to its factory default
state by pressing and holding the WPS/Reset button for at least
10 seconds. The LED will display on (
red ) while the device resets.
The wireless bridge is ready when the LED is flashing (red).
IV-6-1. Upgrade Firmware
Selecting “Firmware upgrade” from the “Configuration
Tool” menu allows you to update the system firmware
to a more recent version. You can download the latest
firmware from the Edimax website.
Do not switch off or disconnect the wireless bridge
during a firmware upgrade, as this could damage
the device.
It is recommended to use a wired Ethernet
connection to upload a firmware file.