Browser based configuration interface, Iv. browser based configuration interface – Edimax Technology CV-7438nDM User Manual
Page 22
22
IV. Browser Based Configuration Interface
After you have setup the wireless bridge as detailed in
included QIG, you can further configure the settings of the wireless bridge,
using the browser based configuration interface.
A computer is required to access the browser based configuration
interface after initial setup. Smartphones and tablets cannot
access the browser based configuration interface.
Please ensure that your computer is set to use a dyanmic IP
address. Refer to
Appendix V-1. Configuring your IP Address
for
more information.
To access the browser based configuration interface enter
into the URL bar of a browser on a network device
connected to the same Wi-Fi network as the wireless bridge.
If you can not access the browser based configuration following
the instructions below, connect the CV-7438nDM to a computer
using an Ethernet cable and try again.
You will be prompted for a username and password. The default username is
“admin” and the default password is “1234”.