Hoover RUSH EXTRA TRE 420 019 - Manual (Page 4)

clEANER MAINTENANcE
AccESSORIES AND NOZZlES
Emptying the dust Container
when the dust reaches the max level indicator in the container empty the dust bin.
important: To maintain optimum performance do not allow the dust to sit higher than
the max level.
Release the container by sliding the dust container release button towards the rear of 1.
the cleaner. [13] lift the dust container from the cleaner main body.
Hold the dust container over a bin with one hand and press the bin container door 2.
open trigger. [14]
close the dust container door and refit to the cleaner main body. 3.
Cleaning the washable filters
The cleaner is fitted with a blue filter pack. To maintain optimum cleaning performance
regularly remove the the filters and tap against the side of the bin to release dust. The
filters should be washed every 3 months or when the filter has excessive dust level.
important: all bagless cleaners require regular filter cleaning. Failure to clean your
filters may result in air blockage, overheating and product failure. this may invalidate
your guarantee.
important: Always ensure the filters are fully dry before use.
to access the pre-motor filter:
Release the container by sliding the dust container release button towards the rear of 1.
the cleaner. [13] lift the dust container from the cleaner main body.
Hold the dust container with one hand and with the other hand rotate the bin handle 2.
anti clockwise to release it from the dust container. [15]
Remove the blue filter pack located in the dust container handle. 3. [16]
Remove the foam filter from the filter pack. 4. [17]
Gently tap and wash the filter using warm water. Do not use hot water or detergents. 5.
Remove excess water from the filter and leave to dry fully before re-using. [18]
Reassemble to filter pack once fully dry and refit to the cleaner. 6.
important: Do not use the product without the filter pack fitted.
to access the exhaust filter:
Unclip the exhaust filter from the rear of the cleaner. 1. [19]
Gently tap and wash the filter using warm water. Do not use hot water or detergents. 2.
Remove excess water from the filter and leave to dry fully before re-using.
USING yOUR clEANER
2 *Certain models only
** may vary depending on model
gB
All accessories can be fitted to the end of the hose handle or to the end of the telescopic
tube.
dusting Brush – for bookshelves, frames, keyboards and other delicate areas. To extend
the brushes push the button on the body of the tool. [22]
Crevice tool – for corners and hard to reach areas. [23]
Furniture nozzle – for soft furniture and fabrics. [24]
parquet Caresse nozzle* – for parquet floors and other delicate floors. [1U]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deepcleaning
on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs removal.
[1V]
allergen remover mini turbo nozzle* – Use the mini turbo nozzle on stairs or for
deepcleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal. [1W]
grand turbo nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1X]
Stair Cleaning Stretch hose* – Use for stair cleaning and areas requiring long reach. [1Y]
Use this in addition to the standard cleaner hose. Attach the hose to the end of the hose
handle. [25]
important: Do not use the grand turbo and mini turbo nozzles on rugs with long fringes,
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while
the brush is rotating.
Extract power cord and plug it into the power supply. Do not pull the cord beyond the 1.
red marker. [6]
Adjust the telescopic tube to the desired height by moving the telescopic release 2.
button up and raise or lower the handle to the most comfortable cleaning position.
[7]
carpet and floor Nozzle** - Select carpet care control** height by pressing the pedal 3.
in the nozzle. [8]
hard Floor: brushes are lowered to protect the floor.
Carpet: brushes are raised for the deepest clean.
Switch the cleaner on by pressing the On/Off button on the cleaner main body. 4. [9]
Adjust the suction by moving the suction regulator to the desired level.* 5. [10]
Switch off at the end of use by pressing the On/Off button. Unplug and press the cord 6.
rewind button to wind the power cord back into the cleaner. [11]
To store your cleaner adjust telescopic tube to the lowest height setting and park the 7.
nozzle in the parking slot on the cleaner main body. [12]
RushExtra__1-4_union.indd 2 22/07/2011 16.02.16