Festool KAL User Manual
Page 12
GB KAL
12
– The device is not intended
for use by persons (including
children) with limited physi-
cal, sensory or mental ability
or without sufficient experi-
ence and/or knowledge, un-
less they are supervised by a
person responsible for their
safety or have been instruct-
ed on how to use the device.
Children should always be su-
pervised to ensure that they do
not play with the device.
– Protect the battery pack
from excessive heat or con-
stant heat sources such as
sunlight or naked flames.
There is a risk of explosion.
– Never use water to extin-
guish burning LiIon battery
packs, always use sand or a fire
blanket.
6
Operation
6.1 Charging the integral bat-
tery pack
L
Prior to initial operation:
charge battery pack for approx.
3 h!
X
Insert the mains or vehicle
charging adapter into the con-
necting socket [1-4].
When the light is switched off, the
charging state indicator [1-1] dis-
plays the operating state of the inte-
gral battery for the duration of the
charging process:
Charging state indicator green -
flashing
Integral battery is charged with
maximum current.
Charging state indicator green -
permanently lit
Integral battery is charged to 80%
and then charged fully with a re-
duced current.
Charging state indicator red -
flashing
General fault indication, e.g. incom-
plete contact, short circuit, battery
faulty.
Charging state indicator red -
permanently lit
Battery temperature is outside the
permitted range.
6.2 On/Off switch [1-2]
The on/off switch [1-2] has three
settings:
– Press once -> activate LED with
max. luminosity (stage 1:
100%)
– Press twice -> reduce the lumi-
nosity (stage 2: 30%)
– Press three times -> switch off
6.3 Setup options
Attachment handle [1-3]
The folding attachment handle al-
lows you to hang the working light
from scaffolding or similar struc-
tures.